How To Clean Out Deck Screws For Removal

@Bib is admittedly right in the answer above, simply in the grand tradition of skinning a cat multiple ways, here'due south an alternate approach. I think this would be faster than an oscillating tool and easier than a sawzall. (Though both are keen tools to have -- don't permit me discourage y'all there.)

Given that you lot're not trying to relieve the deck boards, I'd use a circular saw to rough cut them beginning, then use a sledge hammer to knock them off the screws. Anything that is bad-mannered for the sledge can usually exist removed with a 2' pry bar. If any screws remain, outset hit them sideways with a hammer to encounter if you tin can break them; otherwise, twist them out with vise grips. (This assumes that y'all're taking out a large percentage of deck boards... if y'all're just plucking a few strategically, this advice doesn't apply. However, if a few of your deck boards are bad, it'due south probably not long before all of your deck boards are bad, so doing everything at once might work well.)

Cut strategy: if your deck is nearly ground level, then just run the circular saw between each joist. This is a lot similar cutting the tree limb that you're sitting on, so care is required as yous get to the edge. If the deck is a little higher, (so difficult to access from the ground), cutting so that you've got walkways of deck boards that bridge two joists. The blueprint would expect like this:

Once again, apply circumspection, every bit you lot're relying on less and less structure to keep you from tumbling.

Source: https://diy.stackexchange.com/questions/101535/how-to-remove-screws-from-old-decking

Posted by: thompsonprien1967.blogspot.com

Share this post